EasiCut 420/450/510 instruction manual EasiCut 600XT instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna Outdoor Products Customer Service Department direct Telephone : 0870 609 1901 Fax : 0870 609 1902 If not used properly this product can be dangerous! This product can cause serious injury to...
Page 3
Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable. 12. Always wind cable carefully, avoiding kinking. 13. Use only on AC mains supply voltage shown on the product rating label.
Page 4
CABLES IMPORTANT • Use only 1.00mm size cable up to 40 metres length maximum. Maximum rating : 1.00mm size cable, 10 amps 250 volts AC. • YOUR HEDGETRIMMER IS SUPPLIED WITH CABLE WIRED DIRECTLY INTO THE PRODUCT. 1. Mains Cables and Extension Cables are avail- able from your local Approved Service Centre.
Before starting your Hedgetrimmer. • Securing the cable in the Belt Clip helps keep the cable away from blade. 1. Push up the hook on the Belt Clip (B1) 2. Place the rear section of the Belt Clip behind your belt (B2) 3.
How to Use your Hedgetrimmer 1. Inspect area to be cut before each use - remove objects which can be thrown or become entangled in the cutting blades. 2. Always keep the Hedgetrimmer in front of your body. Hold handle firmly with both hands and stand in a secure and stable position.
Fails to Operate 1. Is the Power Turned On? 2. Check the fuse in the plug, if blown replace. 3. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Cutting blade stops under load 1.
Service Centre. Should you require service under the terms of our guar- antee the Service Centre will require proof of purchase. All of the centres listed stock genuine Flymo Spare Parts. NOTE: Our Service Repairers act on their own behalf...