Table of Contents
Advertisement
Chapter 4
BIOS Configuration
1. From the DOS prompt, rename the BIOS file that you have down-
loaded to "amiboot.rom" and copy it on to a floppy disk.
2. Insert the floppy disk with the BIOS upgrade into the A: drive.
3. Turn the power off.
4. While holding the <Ctrl> and <Home> keys, turn the power on. The
system will begin to read from the A: drive, and write the BIOS
information contained on the floppy disk in that drive to the EEPROM
ROM chip. When the BIOS has been totally reprogrammed, the
system will reboot with the new BIOS in operation.
5. If the system does not reboot in three minutes, power down the
0system, wait a few seconds, and then turn the power back on again.
You will be prompted to press <F1> to run Setup. You may check your
settings at this time, or simply save and exit the program.
70
http://www.tyan.com
Advertisement
Table of Contents
