Table of Contents
Advertisement
Chapter 2
Board Installation
Contact your hard disk drive manufacturer or documentation for more
information.
Some symptoms of incorrectly installed HDDs are:
•
Hard disk drives are not auto-detected: may be a Master/Slave
problem or a bad IDE cable. Contact your vendor.
•
Hard Disk Drive Fail message at bootup: may be a bad cable or
lack of power going to the drive.
•
No video or beeps on bootup: usually means the cable is on
backwards.
•
Hard drive lights are constantly on: bad IDE cable or defective
drives/motherboard. Try another HDD.
•
Hard drives do not power up: check power cables and cabling.
May also be a bad power supply or IDE drive.
Now that you have installed your IDE drives, your floppies are next.
Pin 1 on the floppy cable is usually denoted by a red or colored stripe
down one side of the cable (see Figure 5). Most of the current floppy
drives on the market require that the colored stripe be positioned so that
it is right next to the power connector. In most cases, there will be a key
pin on the cable which will force you to connect the cable properly.
Figure 5
14
http://www.tyan.com
Advertisement
Table of Contents
