Example Of Ftp Commands From The Command Line; Gui-Based Ftp Clients; File Maintenance Over Wan; Figure 409 Ftp Session Example - ZyXEL Communications ZyWall 5 Series User Manual

ZyWALL 5/35/70 Series User's Guide

47.3.3 Example of FTP Commands from the Command Line

Figure 409 FTP Session Example

47.3.4 GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-based FTP
clients.

Table 247 General Commands for GUI-based FTP Clients

COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory

47.3.5 File Maintenance Over WAN

TFTP, FTP and Telnet over the WAN will not work when:
1 The firewall is active (turn the firewall off in menu 21.2 or create a firewall rule to allow
access from the WAN).
2 You have disabled Telnet service in menu 24.11.
3 You have applied a filter in menu 3.1 (LAN) or in menu 11.5 (WAN) to block Telnet
service.
666
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds
297.89Kbytes/sec.
ftp> quit
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the server
for anonymous access. Anonymous logins will work only if your ISP or
service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary mode
Specify the default remote directory (path).
Specify the default local directory (path).
Chapter 47 Firmware and Configuration File Maintenance