Figure 7-8 Wan Node Display; Figure 7-9 Wan Node Mux; Figure 7-10 Wan Node Vpi - ZyXEL Communications Prestige 650M-6x User Manual

Syntax:
wan node display <ch-name>
This command displays the settings for the current node.
An example is shown next.
ras> wan node display
WAN node index = 1
Active = yes
Route IP = off
Brdige = on
Name = MyISP
Encapsulcation <RFC1483 > = 1
Mux <1:LLC|2:VC> = 1
VPI/VCI = 8 / 35
QOS Type <2:CBR|3:UBR|4:VBR> = 3
QOS PCR/SCR/MBS =
Syntax:
wan node mux <llc|vc>
Use this command to set the multiplexing method used by the Prestige.
An example is shown next.
Syntax:
wan node vpi <vpi>
Enter the Virtual Path Identifier from 0 to 255.
An example is shown next.
Syntax:
wan node vci <vci>
Enter the Virtual Channel Identifier from 32 to 65535.
An example is shown next.
WAN Setup
0,

Figure 7-8 wan node display

ras> wan node mux vc

Figure 7-9 wan node mux

ras> wan node vpi 100

Figure 7-10 wan node vpi

0, 0
Prestige 650M-6x User's Guide
7-7