ZyXEL Communications Prestige 650M-6x User Manual page 29

MAIN
COMMAND
hwsar
adsl
Commands Introduction
Table 2-1 Command Summary
SUB-COMMAND
vci [num]
qos [ubr|cbr|vbr]
pcr [num]
scr [num]
mbs [num]
bridge <on|off>
routeip <on|off>
disp
clear
chandata
opmode
linedata far
near
perfdata
rateadap on
off
reset
status
open
Prestige 650M-6x User's Guide
DESCRIPTION
Enter the Virtual Channel Identifier from 32 to 65535.
This is the ATM QoS type.
This is the maximum rate at which the sender can
send cells.
This is the mean cell rate of each bursty traffic
source.
This is the maximum number of cells that can be sent
at the PCR.
Use this command to select have the Prestige act as
a bridge.
Use this command to select have the Prestige act as
a router.
This command displays hwsar packets
incoming/outgoing information.
This command clears hwsar packets information.
This command displays the ADSL line channel
information.
This command displays the operating mode of the
ADSL line.
Show ADSL far end noise margin
Show ADSL near end noise margin
Show performance information, CRC, FEC, error
seconds.
Turn on rate adaptive mechanism
Turn off rate adaptive mechanism
Reset ADSL modem, and must reload the modem
code again
ADSL status (ex: up, down or wait for init)
Initialize ADSL connection
2-5