ZyXEL Communications Prestige 650M-6x User Manual page 28

Prestige 650M-6x User's Guide
MAIN
COMMAND
password <new password>
socket
cpu
ether
config
driver
version
wan
node
2-4
Table 2-1 Command Summary
SUB-COMMAND
display
cnt disp <name>
Status <ch-name>
config
index [1~2]
clear
save
ispname <name>
enable
disable
encap <1483 >
disp
mux <llc|vc>
Vpi <vpi>
DESCRIPTION
This command sets the new password.
This command shows system socket information.
This command shows CPU utilization.
This command shows LAN settings.
This command shows Ethernet driver counters.
This command shows LAN status.
This command sets MAC phy mode.
[0|1=auto|normal] [0|1=10|100]
[0|1=HD|FD] <ch-name>
This command shows Ethernet device type.
Use this command to set a remote node as the
current node to apply node commands.
This command clears the current nodes statistics
This command saves the current nodes settings.
Use this command to identify the ISP used by this
node.
This command enables the currently selected remote
node.
This command disables the currently selected remote
node.
Use this command to set the method of
encapsulation used by the Prestige.
This command displays the settings for the current
node.
Use this command to set the multiplexing method
used by the Prestige.
Enter the Virtual Path Identifier from 0 to 255.
Commands Introduction