Table of Contents
Advertisement
Prestige 650M-6x User's Guide
OPTION
-i interval
-I interface
address
-l preload
-p patten
-s packetsize
-t ttl
Some examples are shown next.
ras> ip ping -c 10 -i 2 192.168.1.1
PING 192.168.1.1 (192.168.1.1): 56 data bytes
64 bytes from 192.168.1.1: icmp_seq=0 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=1 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=2 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=3 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=4 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=5 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=6 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=7 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=8 ttl=255 time=0.0 ms
64 bytes from 192.168.1.1: icmp_seq=9 ttl=255 time=0.0 ms
--- 192.168.1.1 ping statistics ---
10 packets transmitted, 10 packets received, 0% packet loss
round-trip min/avg/max = 0.0/0.0/0.0 ms
ras>
8-4
Table 8-1 Ping Commands
This is wait interval seconds between sending each packet.
The default is to wait for one second between each packet normally, or not to wait in
flood mode. Only super-user may set interval to values less 0.2 seconds.
This set source address to specified interface address. Argument may be numeric IP
address or name of device. When pinging IPv6 link-local address this option is
required.
If preload is specified, ping sends that many packets not waiting for reply. Only the
super-user may select preload more than 3.
You may specify up to 16 ''pad'' bytes to fill out the packet you send. This is useful for
diagnosing data-dependent problems in a network. For example, -p ff will cause the
send packet to be filled with all ones.
This specifies the number of data bytes to be sent. The default is 56, which translates
into 64 ICMP data bytes when combined with the 8 bytes of ICMP header data.
This sets the IP Time to Live (TTL).
Figure 8-3 Ping Commands Example-1
DESCRIPTION
IP Configuration
Advertisement
Table of Contents
