Prestige 650M-6x User's Guide
Syntax:
ether driver status <ch-name>
This command shows LAN status.
An example is shown next.
ras> ether driver status enet0
Syntax:
ether driver config [0|1=auto|normal] [0|1=10|100] [0|1=HD|FD] <ch-
name>
This command sets MAC phy mode.
An example is shown next.
FIELD
auto|normal
10|100
HD|FD
<ch-name>
5-4
ChanID
=
eq
=
ifaceType
=
mac_p
=
940d2a4c, ec_p
LinkSt
=
MbufCacheAlloc =
Reset counts
=
txUnReleasedBufCnt
=
Figure 5-6 ether driver status
ras> ether driver config 0 0 0 enet0
Figure 5-7 ether driver config
Table 5-1 Service Characteristic
When auto-negotiation is turned on, an Ethernet port negotiates with the peer
automatically to determine the connection speed and duplex mode. See section
5.1.1 for more information.
Manually set the connection speed to 10Mbps or 100Mbps.
Select either Half Duplex or Full-Duplex, see section 5.1.2 for more information.
Specify an Ethernet channel to apply your settings. Currently only one enet0 is
supported.
0, Mac
= 00:a0:c5:9c:7b:83
0, dq
=
0, TxSending
=
=
7, CacheQueue
=
0, MbufCacheEmpty =
0, Phy address
=
10
DESCRIPTION
0
0
94147058
0
0
1f
Ethernet Setup