Chapter 4 Remote Node Configuration; Remote Node Setup; 4.1.1 Remote Node Profile; Figure 4-1 Menu 11 - Remote Node Setup - ZyXEL Communications Prestige 642 User Manual

A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up
Internet access, you are actually configuring one of the remote nodes.
4.1

Remote Node Setup

This section describes the protocol-independent parameters for a remote node.

4.1.1 Remote Node Profile

To configure a remote node, follow these steps:
Step 1. From the Main Menu, select menu option 1. Remote Node Setup
Step 2.
When Menu 11 appears, as shown below, enter the number of the remote node that you wish to
configure.
When Menu 11.1 - Remote Node Profile appears fill in the fields as described in the table that follows to
define this remote profile. The Remote Node Profile Menu Fields table shows how to configure the Remote
Node Menu.
Remote Node Configuration
Remote Node Configuration
In this chapter, we discuss how to configure a remote node.
Menu 11 - Remote Node Setup
1. nodename
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter Node # to Edit:
Figure 4-1 Menu 11 – Remote Node Setup
Prestige 642 ADSL Modem
Chapter 4
4-1