The Zero And Span Functions - Teledyne 2010B Operating Instructions Manual

Thermal conductivity analyzer

Hide thumbs

Table of Contents

Thermal Conductivity Analyzer

The leftmost digit (under

tored. Use the

The

the analyzer. You do not need to actually flow gas.

The

AL concentration of the span gas being simulated.

If the

corrected. Press ESCAPE to return to the previous screen. Select and Enter

to Calibration Mode screen.

There are two ways to linearize:

requires as many calibration gases as there will be correction points along the

curve. The user decides on the number of points, based on the precision re-

quired.

The manual mode only requires entering the values for each correction

point into the microprocessor via the front panel buttons. Again, the number of

points required is determined by the user.

4.4

(1) The Model 2010B can have as many as three analysis ranges plus a

special calibration range (Cal Range); and the analysis ranges, if more than one,

may be programmed for separate or identical gas applications.

(2) If all ranges are for the same application, then you will not need the Cal

Range. Calibrating any one of the ranges will automatically calibrate the others.

(3) If: a) each range is programmed for a different gas application, b) your

sensor calibration has drifted less than 10 %, and c) your Cal Range was cali-

brated along with your other ranges when last calibrated, then you can use the

Cal Range to calibrate all applications ranges at once.

If your Model 2010B analyzer fits the paragraph (3) description, above,

use the Cal Range. If your analyzer has drifted more than 10 %, calibrate each

range individually.

CAUTION: Always allow 4-5 hours warm-up time before calibrat-

) is the number of the data point being moni-

keys to select the successive points.

value is the input to the linearizer. It is the simulated output of

value is the output of the linearizer. It should be the ACTU-

value shown is not correct, the linearization must be