Table of Contents
Advertisement
Chapter 2. CLI Syntax Reference
93
For 9650SE and 9690SA controllers running firmware 9.5.1 or later, auto-
verify works in conjunction with the basic verify schedule. When autoverify
is on and the basic verify schedule is used (verify=basic), a verify will
automatically run at the basic verify time (Friday at midnight, by default). If
the system is not on at that time, verification will start the next time the
system is powered on. When the autoverify is on and the advanced verify
schedule is used (verify=advanced), autoverify will run during the times
specified with the advanced schedule. You can use the show verify command
to display the existing schedule windows. For more information about using
basic or advanced verify, see "/cx set verify=advanced|basic|1..5" on page 73.
For all 9000 series controllers running pre-9.5.1 firmware, auto-verify allows
the controller to run the verify function once every 24 hours. If verify
schedule windows are set up and enabled, then the controller will only start an
automatic verify task during the scheduled time slots. If the verify takes
longer than the schedule window, the verify process will be paused and
restarted during the next verify schedule window.
Table 11: Autoverify Behavior (when enabled)
Basic Verify Schedule
(verify=basic)
Advanced Verify
Schedule
(verify=advanced)
Verify Schedule is
Disabled
(verify=disable)
Verify Schedule is
Enabled
(verify=enable)
For more about setting up verify schedules, see "Setting Up a Verify
Schedule" on page 67.
3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.2
9650SE and
9650SE and
9690SA with
9690SA with
9.5.1 or later
firmware 9.5 or
9.5.0.1
Runs at weekly
N/A
day and time
Follows
Advanced Verify
N/A
Schedule
Runs at any
Runs at weekly
time, as
day and time
determined by
(Same as Basic)
firmware
Follows
Follows verify
Advanced Verify
schedule
Schedule
9550SX and
earlier
N/A
N/A
Runs at any
time, as
determined by
firmware
Follows verify
schedule
Advertisement
Table of Contents
