Paper Replacement With Logging Printer B2Q191 - Siemens Synova FC330A Operating Manual

Paper replacement with logging printer B2Q191

Switch off the printer
B
A
I
Change of printer paper
Enable the printer
Spare paper rolls
Print intensity
Fire & Security Products
Siemens Building Technologies Group
Before changing the printer paper disable the printer by the control panel menu (+ page 44).
E
C
II
1. Remove the screws on the right−hand side or open the hinged cover with the key.
2. Swing out the printer unit.
3. Undo the clamp H and remove the used paper roll (see picture IV).
4. Lift the paper flap A and attach the a new paper roll on the spindle B. Assure that the moving
direction of the paper roll is clockwise (see picture I).
5. Press the leading edge of the paper tape lightly against the flap A and feed it through slot C
into the printer (see picture II).
6. Press down the release lever D and shove the paper tape through the printer (see picture III).
7. Relinquish release lever D. The paper can now be transported by means of the knurled
wheel E (see picture III).
8. Feed the paper tape through slot F.
9. Thread the leading edge of the paper around the take−up roller G and fix it with clamp H (see
pictures IV and V).
10. Press the winding up key J (see picture III) to wind up the paper and to reset of the "End of
paper" fault.
After changing the printer paper, enable the printer by the control panel menu (+ page 44).
Following types of paper rolls are available for the printer:
part no. 279 977 (4 pieces)
n
JUJU TP 50KS−A
n
HOSHU PS 65 B1
n
MITSUBISHI F−200 U7X
n
If the print intensity is too low, call the SIEMENS service organization.
F
H
D
J
III
G
B2Q101
IV
V
45
e1973c-13
02.2004