Table of Contents
Advertisement
How are alarm messages shown on the text display?
How to respond in case of alarm
What to do after an alarm
Fire & Security Products
Siemens Building Technologies Group
A single alarm message on the text display
consists of 2 lines as shown in the example to
the right.The first line tells that the alarm was
given in zone 5 by the element 1 of this zone,
which was an automatic fire detector. The
numbers at the end of the line tell, that this is
the first of in total 3 alarm messages. The se-
cond line gives the explicit location of the re-
sponding detector.
The 3. and the 4. line hold the same information for the last alarm message issued. In this case a
manual call point was actuated in zone 3 of the building, which is located in the ground floor main
entrance.
1. alarm message
zone 5, element 1
"1st floor canteen"
Scrolling alarm messages
Additional pending messages can be retrieved using the scroll key.
Ì
Press the scroll key
"
The first two lines are superseeded with the subsequent alarm message.
Ü
Retrieving supplementary informations
Supplementary informations to the alarm messages can be retrieved by using
tells the type of the responding device, e. g. automatic detector.
F1
n
tells the cabling address and the type number of the responding device (device address).
F2
n
Press
(or
).
"
F1
F2
The second line in the text display is superseeded with the supplementary information.
Ü
Press the scroll key to retrieve supplementary information of subsequent alarm messages.
"
1. Press the Acknowledge key
Reset system if normal conditions appeared.
"
If a manual call point was activated while the alarm, insert a new front glass in the actual call
"
point.
ALARM zone ###/## / ######
1st floor canteen
ALARM zone ###/## / ######
ground floor main entrance
3. alarm message
zone 3, element 1
"ground floor main entrance"
below the text display.
Í
.
1( 3)
3( 3)
and
:
F1
F2
19
e1973c-3
02.2004
Hide quick links:
Advertisement
Table of Contents
