Siemens Synova FC330A Operating Manual page 18

Automatic switchover
Extra time
Function extra time
activated p
not activated p
Extra time max.
14
Fire & Security Products
Siemens Building Technologies Group
Toggle via menu
1. Press .
St
Display shows
Ü
2. Select option 4. ä 1. ä 1.
Display shows
Ü
3. If the operating state has to be changed
to
− "manned": select option 1.
− "unmanned": select option 2.
If mode "manned" is selected
Ü
Display shows
Ü
for a few seconds
The automatic switchover is used for example, to prevent the system status "manned" during
nighttime when no operating personnel is present: The system switches automatically to status
"unmanned" at a defined time (e. g. after the office hours). The same scheme can be used for
unattended times during weekends or holidays. The automatic switchover scheme is defined by
the service engineer. No user action is required.
Automatic switchover from "manned" to "unmanned": at
n
Automatic switchover from "unmanned" to "manned": at
n
The function "extra time" allows to set the system to manned operation for a preset time, after the
automatic switchover to unmanned has taken place.
1. Press .
St
Display shows
Ü
2. Select option 4. ä 1. ä 1.
Display shows
Ü
The actual display depends on the initial mode, here e. g. mode unmanned (i. e. after
Ü
17:00).
3. Select option 3.
Display shows
Ü
4. Enter the extra time.
The time until the system is set to manned mode is displayed.
Ü
SELECT: 1. ENabling
(main menu) 2. DISabling
*
3. INFO polling
4. other functions
mode 'manned' until ##:##,
sel. #, 2.> manned
*
hm: back to menu
mode 'manned' TERMINATED
> system is set to NORMAL OPERATION
*
timeout /hm: menu
SELECT: 1. ENabling
(main menu) 2. DISabling
*
3. INFO polling
4. other functions
mode 'unmanned'
(hm = INTERRUPT)
*
hm: back to menu
EXTRA TIME h/min? (max. ##:##)
*
hm: back to menu
1.> unmanned
3.extra time
Stop: end operating
Stop: end operating
p.m.
a.m.
2. > 'manned'
3. extra time
Stop: end operating
Stop: end operating
e1973c-2
02.2004