When Moving The Unit - Roland FJ-50 User Manual

3-7 When Moving the Unit...

NOTICE
When moving the unit, first carry out head washing, then secure the carriage in place. Head washing requires
three optionally available cleaning cartridges.
1
If there is material loaded, hold down the [SETUP]
key for 1 second or longer to cancel setup, then
remove the material (see "2-7 Ending Printing
Operations Remove the Material").
3
Press the [ ] key to make the following screen
appear on the display.
INK CONTROL
EMPTY MODE
5
When the display shown in the figure appears, discard
the discharged ink in the drain bottle.
* Be sure to discard the discharged ink.
Attempting to replace the ink while discharged ink
remains may cause discharged ink to overflow from
the bottle.
DISCARD
7
When all ink cartridges have been removed, head
washing starts. Follow the messages on the display to
carry out the procedure.
Messages appearing during head washing
SET CL-LIQUID
[KCMcmY]
Insert a cleaning cartridge into the ink
cartridge port for the flashing color.
REMOVE CL-LIQUID
[KCMcmY]
Remove the cleaning cartridge from the ink
cartridge port for the flashing color.
K = Black C = Cyan
m = Light Magenta (G = Green)
DRAIN TANK
M = Magenta c = Light Cyan (O = Orange)
Y = Yellow
2
Press the [MENU] key and [
following screen appear on the display.
4
Use the [ ] key to select [HEAD WASH], then press
the [ENTER] key.
INK CONTROL
HEAD WASH
6
Mount the drain bottle and press the [ENTER] key to
display the screen shown in the figure.
REMOVE CARTRIDGE
8
When the display shown in the figure appears, head
washing is finished.
Press the [POWER] key to switch off the sub power.
The POWER LED goes out
INK CONTROL
HEAD WASH
9
When the POWER
LED goes out, turn off
the main power switch.
Continued on the next page
3 Maintenance
] key to make the
MENU
INK CONTROL
[KCMcmY]
43