When Not In Use - Roland FJ-50 User Manual

2 Basic Operation
When sending a material-cutting command from the computer to separate
the material automatically
* When the material-cutting command has not been set to "enabled" at the computer, automatic separation of
the material is not performed, even when the following setting is made.
1
Press the [MENU] key and [
following screen appear on the display.
2
Press the [ ] key to make the following screen
appear on the display.
AUTO SHEET CUT
ENABLE ENABLE
3
Use the [ ] key to select [DISABLE], then press the
[ENTER] key.
AUTO SHEET CUT
ENABLE DISABLE

2-8 When Not in Use...

NOTICE
When not in use, move the sheet loading lever toward the
back of the unit to leave the pinch rollers in the raised state.
The pinch rollers may be deformed if allowed to remain in
the lowered state.
32
] key to make the
MENU
AUTO SHEET CUT
The material-separating location during
continuous printing
Start of the next printing operation
End of printing
Location where separated
Margin (value set for [PAGE MARGIN])
10 mm
(3/8")
10 mm (3/8")
Sheet loading lever