4 User's Reference
Top
Submenu
menu
—
AUTO
SHEET CUT
—
PAGE
MARGIN
—
MENU UNIT
—
SYSTEM
REPORT
—
FACTORY
DEFAULT
—
INK LEFT
54
This selects whether the material-cutting command is enabled or
disabled.
When set to [ENABLED], the material is cut automatically when the
computer sends a material-cutting command.
For more information, see "2-7 Ending Printing Operations -- Separat-
ing the Printed Portion."
This makes the setting for the margin between pages.
When outputting a number of pages continuously, you can establish a
margin between the pages.
For more information, see "2-9 Other Functions -- Setting the Page
Margins."
This selects millimeters or inches as the unit of measurement for the
width displayed on the top menu after setting up the material. When
inch display is used, values are displayed to the first digit to the right of
the decimal point.
This prints the current status of settings and other system information.
This returns all menu settings to their original values when shipped
from the factory.
For more about the factory defaults for the various settings, see the
"Default value" entry for each menu setting in this section.
This shows the amount of ink left after each of the ink cartridges has
been installed.
The fewer the markers ("
"), the less ink is left.
* If a partially used ink cartridge is removed and reinstalled, or if a
partially used ink cartridge is installed, the cartridge is taken to be
unused, and the displayed amount of remaining ink is not true.
For more information, see "3-2 Remaining Ink."
Function
Setting
Default
range
value
ENABLE/
ENABLE
DISABLE
0 to 100
10 mm
mm
(In steps of
10 mm)
mm/INCH
mm
—
—
—
—
—
—