Roland FJ-50 User Manual page 22

2 Basic Operation
3
Place the roll material on the shaft and fit the hole at the left-hand side all the way onto the left-hand media flange.
4
Fit the right-hand media flange all the way into the hole on the right-hand side of the roll material, and tighten the retainer screw
to secure in place.
Rear
5
Pass the end of the material through the unit from back
to front.
Line up the end of the material with the lines of
reflective tape.
If the front edge of the material has been cut at an
angle, pull out the material so that all of the material
covers the reflective tape.
6
With the material pulled out from the roll stretched
taut with no slack, move the sheet loading lever
toward LOAD.
The pinch rollers lower to hold the material in place.
Sheet loading lever
7
Close the front cover, and press the [SETUP] key.
This detects the width of the material and displays the
printable width.
The SETUP LED lights up
20
Roll material
Top menu
W 1234 mm
FINE BI-DIR
Front
Front edge of the material
Rear
Reflective tape
Entire material
stretched taut