Installing/Removing A Blade - Roland ColorCAMM PNC-5000 User Manual

5-3 Installing/Removing a Blade

NOTICE
Do not touch the tip of the blade. This could impair the cutting performance of the blade.
Installation
1
Insert blade into the blade holder until it
snaps into place with an audible click.
Push-pin
Blade holder
Blade
Adjusting the
Cutter Blade
Blade adjustment may be necessary when:
- cutting material whose carrier paper is thinner than the material itself
- cutting material with no carrier paper
1)
Turn the cap as shown by the
arrow to align the tip of the
blade with the tip of the cap
NOTICE
When cutting is performed after printing, the cap tip of the blade holder may scratch the printed surface. If this is the case,
lengthen the cutter blade extension.
Removal
1
2) Remove the blade holder from
1) Loosen
Leave the tool-securing screw loose. Tightening the screw makes
it more difficult to install the blade holder.
2
When stock vinyl film is to
be cut, tighten the cap all
the way (2.5 mm (about
0.1") of blade extension).
Gap
Amount of cutter blade
extension: 0 mm
the cutting carriage.
Cutting carriage
Tool-securing screw
2) Support the tool-securing screw from below and install the blade
holder.
* Insert the blade holder until the collar is flush with the carriage.
1) Loosen
Tool-securing screw
Turn the cap as
shown by the arrow
2)
Thickness of the
sheet portion
Turn the cap as
shown by the arrow
2
Push-pin
Blade holder
Blade
If a blade was used, wipe the blade with a soft cloth to
remove any material that may cling to it.
5 Basic Operation
Cutting carriage
3) Tighten
Tighten the cap until
gap is eliminated
Amount of cutter blade
extension: 2.5 mm (about
0.1") (maximum length)
Amount of cutter
blade extension
Thickness of the carrier paper
Press the push-pin and
remove the blade from
the blade holder.
7