Pausing Operations; Removing And Reloading A Printed Material For Cutting - Roland ColorCAMM PNC-5000 User Manual

5 Basic Operation

5-7 Pausing Operations

If you want to stop the PNC-5000 momentarily while it is printing or cutting, follow the procedure described below.
1
Press the PAUSE key.
The PAUSE LED
lights up
Printing or cutting is paused.
5-8 Removing and Reloading Printed Material for Cutting
1
Switch off the power,
and set DIP switch
SW-9 to ON.
2
Switch on the power, load the
alignment tool, ribbon
cartridge, and material, then
press the SETUP key.
(The alignment tool is installed
on the cutting carriage in the
same way as a blade holder.)
5
2) Set the align point
Use the cursor keys to
move the tip of the
alignment tool to the
square crop mark at the
lower left area of the
material, then press the
ALIGN POINT SET key.
The ALIGN POINT SET LED lights up
6
Remove the alignment tool from the cutting carriage and install a blade.
7
Send the cutting data from the computer.
NOTICE
When reloading material, be sure to make the settings described above. Crop marks or other marks that have been set with
application software cannot be used.
10
2
To resume printing or cutting
Press the PAUSE key.
The PAUSE LED
goes out
Printing or cutting is resumes.
3
Send the printing data from
the computer.
Before data output begins, two crop
marks are automatically printed on the
left and right areas at the front edge of
the material.
4
When printing is finished press the SETUP key, remove the material and carry
out lamination (or whatever further processing needs to be done).
When done, reload the material in the same position used for printing, and press
the SETUP key. (The SETUP LED goes out.)
2)
To Terminate printing or cutting
1) Halt transmission of printing or cutting instructions
from the computer.
2) Press the SETUP key.
The SETUP LED goes out
Printing or cutting instructions already sent
from the computer to the PNC-5000 are
deleted, and operation stops.
1) Set the base point
Rear
Use the cursor keys to
move the tip of the
alignment tool to the
square crop mark at the
lower right area of the
Front
material, then press the
BASE POINT SET key.
The BASE POINT SET LED lights up
1)
Rear
Front