Printing And Cutting Samples - Roland ColorCAMM PNC-5000 User Manual

6 Printing and Cutting Samples

6 Printing and Cutting Samples
Removing the blank space surrounding a picture
Cutting outline
Material
Adding color to a border
Cutting outline
Material
Correcting Line Pitch
Line pitch: Correct
How to Correct Line Pitch
Hold down the SETUP key and switch on the
power.
Pressing the or
in which the PAUSE LED, BASE POINT SET
LED, and ALIGN POINT SET LED light up.
This pattern indicates the current line pitch.
Use the table at right as a reference to press the
and keys and make the desired line-
pitch setting. After making the setting, press
the SETUP key (the SETUP LED will light
up). (If material is not loaded, be sure to load
one before pressing the SETUP key.) The
setting that has been made is stored in memory
even after the power is switched off. To
change the setting, simply repeat the procedure
just described.
* Distance accuracy cannot be guaranteed when
line-pitch correction has been performed.
12
Line pitch is too narrow, and ink
overlaps.
Line-pitch correction:
Set to "Wide" or "Extra Wide"
Line-pitch
key changes the pattern
correction
Stick
Stick
Extra wide Wide
Lighted Blinking
Dark Blinking
LED
display
pattern
Dark Dark
Line pitch is too wide, and spaces
appear between lines.
Line-pitch correction:
Set to "Narrow" or "Extra Narrow"
Default
Narrow Extra narrow
(no correction)
Dark Dark Dark
Lighted Blinking Dark
Dark Blinking Lighted