(4) Step pattern
The constant-dimension stitching process can be programmed as many as 20 operation steps. The sewing
conditions including the number of stitches, needle bar to be stopped, up/down stop mode, automatic thread
trimming, continuous steps, lifting/lowering of presser foot and normal/reverse feed stitching can be separately
specified for the respective operation steps.
Step 10
Step 9
Step 8
Step 7
Step 6
Press
to display the pattern list screen.
1) Press switch 1 to display the step pattern No. selection pop-up.
2) When switches 2 are pressed and step pattern No. is selected, the screen is automatically changed over
to the step pattern setting screen to display the state of the pattern which has been already specified.
Step 1
Step 2
Step 3
Step 4
Step 5
1
2
Programming procedure is described below taking the
pattern on the left side as an example.
– 47 –