Two-Step Presser Foot Lifter; Changing The Presser Foot - JUKI MCS-1800 Instruction Manual

Using the machine
B
A
C
D
F
1009
9
E
G
(Optional Accessory)

Two-step presser foot lifter

To raise the presser foot push the presser foot lifter up until it en-
gages (A).
It can be raised again to maximum height and held in this position to
provide more space between presser foot and stitch plate for bulky
items (B). To lower the presser foot press the lifter down (C).
"WARNING"
When using the extra lift (B), do not run the machine or turn the
handwheel.

Changing the presser foot

・Switch the machine off (power switch "0").
・ Turn the handwheel to raise the needles.
・ Raise the presser foot.
・ To release the presser foot, press the catch (D).
・ Raise the presser foot shaft to its highest position (B) and remove
the presser foot to the left.
・ To attach the foot, place it under the shank, so that the groove in
the shank lines up exactly with the presser foot pin (E).
・ Lower the shank and the presser foot will engage automatically.
* Lower the presser foot lifting lever and check that the groove in
the shank should line up exactly with the presser foot pin (E). If it
is not lined up, press the catch (D) to line up.
- Cover stitch presser foot (F)
- Chain stitch presser foot (G) (Optional Accessory)