Table of Contents
Advertisement
(3) Communication mode
Changing procedure to the communication mode
Do not perform switch operations other than those described in the following explanations.
Cau tion
Be sure to re-turn the power switch ON after one second or more has passed. If the power is turned
ON immediately after turning it OFF, the sewing machine may not work normally. In this case, turn
ON the power again.
WARNING :
To avoid possible personal injuries caused by movement other than that you desired, do not operate
the switches in the procedure other than those required, as described below, to specify the functions.
1) Turn ON the power. When the needle bar is not in the UP position, turn the handwheel to bring the needle
bar to the UP position.
2) Press switch 1 for approximately three seconds.
3) Press switch 2 for approximately three seconds. The screen changes to the communication mode screen.
Communication mode screen
1
– 70 –
Advertisement
Table of Contents
