Enabling Dhcp; Command Description - IMC Networks iMcV-FiberLinX-II Operation Manual

Enabling DHCP

By pressing D, a screen will appear which allows enabling or disabling DHCP for the
device. By default, the DHCP client is disabled.
Commands List (Space Bar)
The iMcV-FiberLinX-II also includes several device-specific options. To access these
options, press the Space Bar from the Main Configuration screen, type the name of
the action to be performed (as shown below) and press Enter.
Command Description
-------- -----------
cleandb Reboot With Clean Database
download File Download
ifstats Display Port Statistics
rmstats Display Port RMON Statistics
version Show Firmware Version
reboot Reboot Unit
security Configure Non-Standard Network Settings
port Display And Change Port Settings
config Set mode of operation
accounts Add or Delete Username/Password Accounts
sysdescr Change System Descriptions
unit Display And Change Unit Settings
bw Display And Change Bandwidth Settings
->
Press RETURN To Go Back To Main Screen.
Command Description
cleandb Allows reboot of the unit with a clean database.
download Downloads firmware from Server IP address using TFTP.
ifstats Displays interface statistics.
rmstats Displays RMON statistics.
version Displays the firmware and hardware version information.
reboot Reboots the unit.
security Allows non-standard network configuration.
port Display/configure port status values.
config Configure VLAN and Transparent modes of operation.
accounts Add/delete Username/Password accounts.
sysdescr Enter the MIB-II system description information.
unit Display and change unit settings.
bw Display and change bandwidth settings.
26