PROGRAMMING
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
three, (3) times. "PROGRAMMING MODE PROD
NAME LIB" is displayed.
5. Press
. "PROD NAME LIB" is displayed.
6. Press
. "PROD NAME LIB" will be displayed on the top
line, with a flashing cursor on the bottom line.
7. Use
and
to change the character, (A-Z, 1-9,
<space>, and hyphen are available). Use
move the cursor position.
8. Press
to save the new product name. "SAVE LIBRARY
ADD" is displayed.
9. Press
to save. "PROGRAMMING MODE PROD NAME
LIB" is displayed.
10. Press
to exit.
To Modify a Product Name in Library:
1. Press and hold
for three, (3) seconds. "ENTER CODE" is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
"ENTER CODE **** " is displayed.
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
three, (3) times. "PROGRAMMING MODE PROD
NAME LIB" is displayed.
5. Press
. "PROD NAME LIB" is displayed.
6. Use
and
to select Product Name to be modified.
7. Press
. The first character in the Product Name will
start flashing.
8. Use
and
to change the character, (A-Z, 1-9,
<space>, and hyphen are available). Use
move the cursor position.
9. Press
. "SAVE LIBRARY ADD" is displayed.
10. Press
. "SAVE LIBRARY MODIFY" is displayed.
11. Press
to save. "PROGRAMMING MODE PROD NAME
LIB" is displayed.
12. Press
to exit.
Page 32
continued
and
to
and
to
Service Mode
To Change SCK Address:
1. Press and hold
for three, (3) seconds. "ENTER CODE" is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
"ENTER CODE **** " is displayed.
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
three, (3) times. "PROGRAMMING MODE SERVICE
MODE" is displayed.
5. Press
one, (1), time. "Address XX" is displayed.
6. Use
and
to change to the desired SCK Address.
7. Press
to save the changes.
8. Press
to return to "PROGRAMMING MODE SERVICE
MODE"
9. Press
again to exit.
To Perform Limit Switch Test:
1. Press and hold
for three, (3) seconds. "ENTER CODE" is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
"ENTER CODE **** " is displayed.
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
three, (3) times. "PROGRAMMING MODE SERVICE
MODE" is displayed.
5. Press
two, (2), times. "PLATEN" (along with the position
of each switch), is displayed.
6. Use
and
to move the platen up and down. Check
for correct switch operation:
Correct Switch Operation:
Platen Up - U (Closed) L (Open)
Platen Down - U (Open) L (Closed)
7. Press
to return to "PROGRAMMING MODE SERVICE
MODE".
8. Press
again to exit.
Part # JIBSM08 Rev 7 (08/04/09)