Audio And Video Device Connections; Encoder - Fujitsu IP-9500e User Manual

Chapter 2 Installation and Connection
2.3
2.3
2.3.1

Encoder

For audio and video encoding, there are two digital video, one digital audio and two analog audio
terminals to connect audio and video output device.
Digital video input
Connect to SDI IN terminal on the rear panel of IP-9500e using coaxial cable with BNC
connector and input HD-SDI signal. The signal is terminated in 75Ω. The HD signal input is
output from SDI OUT and ANALOG VIDEO OUT (NTSC after downconverted) terminals to
monitor simultaneously.
Digital and analog audio input
Connect to ANALOG AUDIO IN (L), (R) on the rear panel of IP-9500e using the cable with
XLR connector. The impedance is 600Ω balanced. Inputting a signal outside of the rated
value will cause a problem in terms of audio level and noise. To input mono signal, connect
the audio device to ANALOG AUDIO IN (L) terminal. The HD-SDI embedded audio is
supported for the digital audio too.
The figure below shows how to connect the digital and analog audio/video cables. See the next
page for the connection of HDMI and voice communication cables.
NOTE:
Details." For electrical specifications, see Appendix 2.3, "Function Specifications."
Figure Audio and video output device connections
IP-9500e
Audio and Video Device
Connections
For details about connectors and cables, see Section 4.2, "Cable and Connector
20