Table of Contents
Advertisement
2.3
2.3
2.3.1
IP-900E (Encoder)
For audio and video encoding, there are two digital video, one analog video, two digital audio and
two analog audio terminals to connect audio and video output device.
Digital and analog video input
Connect to SDI terminal using coaxial cable with BNC connector and input HD-SDI or
SD-SDI signal. The signal is terminated in 75Ω.
Connect to HDMI terminal using the HDMI cable. The signal is terminated in 50Ω.
Connect to ANALOG VIDEO IN terminal using coaxial cable with BNC connector and input
NTSC/PAL signal. The signal is terminated in 75Ω.
Digital and analog audio input
Connect to ANALOG AUDIO IN (L), (R) using the cable with RCA connector. The
impedance is 54KΩ unbalanced. Inputting a signal outside of the rated value will cause a
problem in terms of audio level and noise. The HD-SDI and HDMI embedded audio is
supported for the digital audio too.
The figure below shows how to connect the digital and analog audio/video cables.
For details about connectors and cables, see Section 4.2, "Cable and Connector
NOTE:
Details." For electrical specifications, see Appendix 2.3, "Function Specifications."
Figure Audio and video output device connections
Audio and Video Device
Connections
100-240V
FG
100M
PWR ALM
OPT
LINK
RDY
IN
/ACT
DWN
MNT
Video & Audio Output Device
27
Chapter 2 Installation and Connection
L
R
IP-900E/IP-900D series
Advertisement
Table of Contents
