Polycom SpectraLink 6000 System Interface Manual page 11

Function Menu Programming
PN: 1725-36137-001_E.doc
SpectraLink 6300 MCU
Note that the function menu defaults set for the handsets associated
with the SpectraLink 6300 MCU can be changed via the SpectraLink
Operator's Console. If the system uses softkeys, to minimize
unwanted interaction between system display and the handset
function menu display, configure the handset menu to include a delay
of one function key. The user will then have to press
the handset menu displays, allowing the first press of the
access softkey functions. See SpectraLink 6300 MCU: Operator's Console
for further procedural information. Another option may be to disable
the softkey menu at the system and exclusively use the SpectraLink
menu. This would remove any unwanted interaction, but may restrict
the number of available features to the number of programmable keys
on the handset.
SpectraLink 6000 MCU
For the SpectraLink 6000 MCU, the handset function menu can only
be changed via remote configuration through the services of Polycom
Customer Support.
SpectraLink 8000 Telephony Gateways
Menu options can be changed in the Administration Console of the
SpectraLink 8000 Telephony Gateways. The Delay function is used
when the PBX uses softkeys. With Delay, when the
pressed, the handset displays the features that are associated with the
softkeys so that one of these features can be selected first. If Delay is
programmed, pressing the
immediately. Under the menu programming section of the
Administration console there is an option to use Delay (same as the
SpectraLink 6300 MCU). See SpectraLink 8000 Telephony Gateway:
Administration Guide for SRP for further details. Also refer to the same
document for details on configuring the telephone switch type
key twice will bring up the menus
FCN
Plan the Interface
twice before
FCN
key to
FCN
key is
FCN
11