Emerson MultiFlex CUB-II Installation And Operation Manual page 67

Name
Suct Xdcr Suction pressure transducer
Disch Xdcr Discharge pressure transducer
Oil Xdcr Analog oil pressure transducer
Case 1 Temp-Case 6 Case temperature sensors #1 through
Temp #6
DrLeg Temp Drop Leg temperature sensor
Term Temp Analog termination temperature sen-
sor (NOT digital — use Defrost Term
Sensor for digital sensors)
Term Dig Digital defrost termination sensor
(NOT analog — Use Term Temp for
analog termination sensors)
Alarm Reset Alarm reset button or switch
Door Switch Door switch
Clean Switch Clean switch
Disch Temp Discharge temperature
SensCtrl 1-2 Input for Sensor Control modules #1
through #2
Comp Proof Compressor proof
Phase Loss Phase loss checking device
KW Analog KW transducer input
Suct Temp Suction Temperature probe
Oil Dig Digital oil pressure switch
NOT USED Input value is unused
Table 8-2 - MultiFlex CUB Input Names
NOTE: You may choose to have multiple in-
puts assigned to the same Sensor Control
module. These inputs will be combined by the
CUB-II's sensor control application using the strategy
chosen in Sensor Control.
Type
The Type field tells the CUB what kind of
sensor is providing the input value. This value of
this field must correspond to the type of input
suggested by the Name field. For example, if the
Name of an input is Suct Temp, CaseTemp1, or
one of the other analog temperature sensor types,
the Type field must be set to TEMP in order for
the input signal from the sensor to be read like a
temperature sensor.
Altering CUB Configuration Using The Hand-Held Terminal
Description
Note that when you choose a value for the
Name field, the CUB does not automatically
enter an appropriate default value in the Type
field. You must manually enter the type for all
sensor inputs.
Table 8-3 lists the input types available for
sensor control inputs.
Input Type
Temperature Analog temperature sensor
12v-100PSI 12v transducer, 0-100PSI
12v-200PSI 12v transducer, 0-200PSI
12v-500PSI 12v transducer, 0-500PSI
5v-100PSI 5v transducer, 0-100PSI
5v-200PSI 5v transducer, 0-200PSI
5v-500PSI 5v transducer, 0-500PSI
Humidity Relative Humidity Sensor
Power-KW Kilowatt transducer, 1-5VDC analog
output signal
Ref Leak Refrigerant Leak Detector
Dewpoint Dewpoint Probe
LM235-TEMP LM235 Temp Probe
Ref Level Refrigerant Level Transducer
Liq Level Liquid Level Transducer
Light Level Light Level Sensor
Pulse-Cnt Kilowatt transducer, pulse KW out-
put signal
Dig-ON/OFF Digital ON/OFF signal
Linear-V 0-5 V linear sensor
Table 8-3 - CUB Sensor Control Input Types
The MultiFlex CUB Hand-Held Interface • 57
Description