Table of Contents
Advertisement
1.13
ASSEMBLING THE MOWER FOR THE FIRST TIME
Unpack the mower: Remove the mower from the packag-
ing and take great care to ensure that the control cables
between the engine and the upper handlebar are not dam-
aged in the process. Check that the loose items have been
supplied correctly. Refer to the delivery checklist opposite.
If any items are missing, contact your local authorised
Hayter Dealer.
Assemble the lower handlebar: Carefully unfold the lower
handlebar into position behind the rear of the mower. Align
with the base of the handlebar and lock in position using the
lower securing knobs.
Assemble the upper handlebar: Carefully unfold the
upper handlebar into position whilst taking great care to
ensure that the control cables remain undamaged, untwisted
and free of kinks.
Align with the lower handlebar and ensure that the rope
guide is correctly orientated. Tighten the upper securing
knobs .
Operate the engine stop lever towards the handlebar and
very slowly pull the engine start-grip away from the engine
until there is sufficient slack in the rope to enable it to be
threaded into the rope guide. Gently release the start-grip
until it rests against the rope-guide.
Align the control cables neatly along each leg of the han-
dlebar and ensure that they are located in the plastic cable
holders. Use a screwdriver to clamp the cable holders in
position.
ASSEMBLY INSTRUCTIONS
DELIVERY CHECKLIST
Description
Quantity
Owner's Handbook
Warranty Reg. Card
ST017
3
1
2
8
7
1. Coach bolt M8
2. Rope guide
3. Engine start grip
4. Upper handlebar
5. Lower handlebar
6. Washer M8
7. Knob
401001EB100398A
1.13
1
1
4
5
6
ST001
Advertisement
Table of Contents
