Preparing The Mower For Storage - Hayter Clipper 46 401R Owner's Handbook Manual

PREPARING THE MOWER FOR STORAGE

1.34
1.34
PREPARING THE MOWER FOR STORAGE
Handlebar storage: Slacken the upper and lower handlebar securing knobs and fold into
the storage position. Take great care to ensure that the control cables do not become
snagged or damaged during folding.
Storage for periods in excess of 30 days: Engines stored in excess of 30 days need to be
protected with Briggs & Stratton fuel additive or drained of fuel to prevent gum from form-
ing in the fuel system or on essential carburettor parts. To ensure your mower is maintained
in good working order it is important that the following procedure is adopted. Refer to the
Maintenance section as necessary.
Drain fuel from the engine by operating the engine until it stops.
Disconnect the spark plug lead.
Change the engine oil.
Remove the engine spark plug and pour 15ml of engine oil into the engine cylinder and
replace the spark plug. Do not exceed the stated volume of oil as engine damage may occur
on re-starting. Do not replace the spark plug lead. Operate the engine stop lever and
slowly pull the engine start - grip once to crank the engine. This will distribute the oil and
help prevent engine corrosion.
Clean grass and debris from the engine cylinder, cylinder head cooling fins, under blower
housing and around and behind the muffler/muffler guard.
Clean all other areas of the mower.
Lubricate the mower.
Treat metal parts with a water repellent anti-corrosion product.
Fold the handlebar to the storage position if desired. Rest the mower deck on wooden
blocks with the wheels clear of the ground.
Cover the mower with a protective sheet and store it in a dry, ventilated area.
401001EB100398A