Table of Contents
Advertisement
1.26
AIR CLEANER SERVICE
Refer to the Maintenance Schedule at the end of this section
and ensure that the recommendations are followed. More
frequent service is required when operating in adverse con-
ditions.
- Replace the element if very dirty or damaged.
- Remove screw (1)
- Carefully remove the air cleaner to prevent debris
from falling into the carburettor.
- Take the air cleaner apart and clean all parts. Wash
the element (2) in liquid detergent and water. Wrap
the element in a clean cloth and squeeze dry.
Saturate the element in engine oil. Wrap in a clean
cloth and squeeze to remove excess oil.
- Install the element and cup (3) into the body (4).
Install the element so that lip (5) extends over the
edge of the body to form a protective seal when
cover is assembled.
-Install the air cleaner securely on the carburettor
with the screw.
SPARK PLUG SERVICE
Use only Briggs & Stratton spark tester (1) to check for a
spark as shown in the diagram.
Replace the spark plug every 100 hours or every season,
which ever occurs first. A spark plug wrench is available
from any authorised Briggs & Stratton service dealer.
The spark plug gap (2) should be checked with a feeler
gauge and set at 0.76mm.
MAINTENANCE
1.26
1
2
3
4
5
1
401001EB100398A
Advertisement
Table of Contents
