Control Cord Connection; Power Cord Connection - Pioneer PDP-505HD Operating Instructions Manual

Centm cord connection Pewer ¢erd connection
When control cord connections are made, remote CONtrOl
operation of connected PIONEER components that bear
the _ logo mark is done through the remote sensor on
this unit
When the connection is made to the CONTROL IN jack
on another unit, the remote sensor of that component will
no longer receive signals Point the remote control unit of
the coRRected compoRent at the remote control sensor
on this unit to control,
Notes
• Make sure the power is turned off when making
connections.
• Please complete all component connections before
making control cord connections.
Main Unit
Connectthe power cord after allcomponentconnections
have been completed
1
Connect the power cord to this unit,
2 Plug the power cord into a power outlet.
OUT
CONTROL
,_ CAUTION
• Use only the power cord provided
• Do not use a power supply voltage other than that indicated
(AC 120 V, 60 Hz) as this may cause fire or electric shock
• For the plasma display, a three core power cord with a ground
terminal is used for efficiency protection Always be sure to
connect the power cord to a three pronged outlet and make
sure that the cord is properly grounded If you use a power
source converter plug, use an outlet with a ground terminal
and screw down the ground line
r:
The control cables (not 1
supplied) are monaural |
cables with mini plugs (no|
resistance). J