Setting The Film Mode - Pioneer PDP-505HD Operating Instructions Manual

Setting the F LM MODE
The FILM MODE function automatically detects movie
film recorded at 24 flames per second, and converts it
into a high quality progressive video image delivering the
picture at the same rate as it was recorded,
• Normally, this fiJnction should be set to "HQ" (High
Quality), however, occasionally this setting may cause
slight syncopation problems with the audio track If you
are bothered by this, sdect "STD" (Standard) If "OFF"
is sdected, normal progressive signal processing is
performed
16"
2,3,4,5 ,
2,3,4,5
1
Press MENU to display the menu screen.
The menu screen appears
2 Press A/V to select PICTURE, then press
SET/SELECT.
3
Press A/V to select OTHER, then press
SET/SELEC_
4
Press A/V to select FILM MODE, then press
SET/SELEC_
5 Press _1/1,_to select FILM MODE setting.
If the setting is changed from "OFF", it is saved to
the USER mode setting (page 30)
After selecting, press SET/SELECT to enter your
selection
6
When the setup is finished, press MENU to exit
the menu screen.
Notes
• "OFF" is set when this unit is shipped from the factory
• FILM MODE setting is possible only with NTSC, 480i sources