Control Cord Connection; Power Cord Connection - Pioneer Elite PRO-1000HDI Operating Instructions Manual

Pioneer operating instructions plasma display pro-1000hdi pro-800hdi
Hide thumbs Also See for Elite PRO-1000HDI:
Table of Contents

Advertisement

Installation and Connections

Control Cord Connection

When control cord connections are made, remote control
operation of connected PIONEER components that bear
the Î logo mark is done through the remote sensor on
this unit.
When the connection is made to the CONTROL IN
terminal on another unit, the remote sensor of that
component will no longer receive signals. Point the
remote control unit of the connected component at the
remote control sensor on this unit to control.
Notes
÷ Make sure the power is turned off when making
connections.
÷ Please complete all component connections before
making control cord connections.
Main unit
CONTROL
IN
OUT
The control cables (not
supplied) are monaural
cables with mini plugs (no
resistance).
16
I
I
PRO-1000HD
/ PRO-800HD

Power Cord Connection

Connect the power cord after all component connections
have been completed.
1
CONTROL
IN
2
OUT
÷ Use only the power cord provided.
CONTROL
IN
÷ Do not use a power supply voltage other than that indicated
OUT
÷ For the plasma display, a three-core power cord with a ground
CONTROL
IN
OUT
1
Connect the power cord to this unit.
Plug the power cord into a power outlet.
CAUTION
(AC 120 V, 60 Hz) as this may cause fire or electric shock.
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged grounded outlet
and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground
terminal and screw down the ground line.
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite pro-800hdi

Table of Contents