Power Save - Pioneer PDP-505HD Operating Instructions Manual

POWER SAVE
Using the POWER SAVE function of this urfit, the power
mode can be automatically put in standby mode when a
video or computer signal has not been detected
(An indication will appear on the screen before the
standby mode is engaged),
1w5
2,3,4
1
Press MENU to display the menu screen.
The menu screen appears
2 Press A/V to select SET UP, then press
SET/SELECT.
4
Press A/V to select the POWER SAVE mode.
• When "OFF" is selected, this unit will stay in
operation mode regardless of whether a
synchronization signal is input or not
• When "MODE1 " is selected, this unit will be put in
standby mode automatically if no new
synchronization signal is input for 8 minutes,
• When "MODE2" is selected, this unit will be put in
the POWER SAVE mode automatically if no new
synchronization signal is input However, if the
synchronization signal is restored, this unit is put
back in operation mode
After selecting, press SET/SELECT to enter your
selection
5 When the setup is finished, press MENU to exit
the menu screen.
Notes
• Tho POWER SAVE setting is common to all inputs (INPUT1 to
INPUT4)
• When SIGNAL is set to "VIDEO", "MODE2" cannot be
selected
To put the unit in operation mode again
P_ess (_ STANDBY/ON on the main unit o_ remote
control unit
When the unit is in the POWER SAVE mode, resuming
PC operation or pressing INPUT on the main unit or
remote control unit can also put the unit in operation
mode again
3 Press A/V to select POWER SAVE, then press
SET/SELECT.
<ARE1349 > En