Control Cord Connection; Power Cord Connection - Pioneer PDP 433CMX Operating Instructions Manual

Control Cord Connection

When control cord connections are made, remote control
operation of connected PIONEER components that bear
the Î logo mark is done through the remote sensor on
this unit.
When the connection is made to the CONTROL IN jack
on another unit, the remote sensor of that component will
no longer receive signals. Point the remote control unit of
the connected component at the remote control sensor
on this unit to control.
Notes
÷ Make sure the power is turned off when making
connections.
÷ Please complete all component connections before
making control cord connections.
Main unit
CONTROL
IN OUT
The control cables (not
supplied) are monaural
cables with mini plugs (no
resistance).

Power Cord Connection

Connect the power cord after all component connections
have been completed.
1
CONTROL
IN
2
OUT
÷ Use only the power cord provided.
CONTROL
IN
÷ Do not use a power supply voltage other than that indicated
OUT
÷ For the plasma display, a three-core power cord with a ground
CONTROL
IN
OUT
Installation and Connections
1
Connect the power cord to this unit.
Plug the power cord into a power outlet.
CAUTION
(AC 100 - 120 V, 50/60 Hz) as this may cause fire or electric
shock.
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged grounded outlet
and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground
terminal and screw down the ground line.
2
15
En