Basic Operation - Marantz PS-17 User Manual

BASIC OPERATION

PLAYBACK OPERATION
This is playback in the stereo mode.
Playing the analog disk/Analog input.
1. Press the POWER ON button on the remote. When the red LED is
on, the unit can be turned on" by pressing any input selector
knob on the front panel.
2. Set the INPUT SELECTOR knob to PHONO on the front panel or
press the PHONO of FUNCTION buttons twice on the remote
unit.
3. Press the SOURCE DIRECT of Surround mode buttons on the
front panel or press the P-DIRE on the remote unit in the AMP
MODE.
4. Play the analog turntable.
Adjust the volume level using the VOLUME knob !2 on the front
5.
panel or press the VOL 5/ button . on the remote.
Caution for analog disk play
• Reduce the volume to the minimum position before replacing the
cartridge or placing the stylus on the disk.
• Do not apply shock to the turntable during play. Otherwise the
stylus may jump and damage the disk surface.
• Avoid installing the turntable near a speaker, for this may cause
howling and make it impossible to increase the listening volume.
• Do not turn power of the turntable off while the stylus is placed on a
disk.
Playing the CD player/Digital Input.
1. Set the INPUT SELECTOR knob to CD on the front panel or press
the CD of FUNCTION buttons twice on the remote unit.
2. Press the AUTO of Surround mode buttons on the front panel or
press the AUTO on the remote unit in the AMP MODE.
3. Play the CD Player.
Adjust the volume level using the VOLUME knob !2 on the front
4.
panel or press the VOL 5/ button . on the remote.
If necessary, adjust the tone, select the TRB+, TRB– and BAS+,
BAS– by the Jog Dial n and press ENT button m in the AMP
MODE on the remote unit.
This is playback in the Multi-channel mode/Digital Input.
Playing the DVD player/Digital Input.
1. Set the INPUT SELECTOR knob to DVD on the front panel or
press the DVD of FUNCTION buttons twice on the remote unit.
2. Press the AUTO of Surround mode buttons on the front panel or
press the AUTO on the remote unit in the AMP MODE.
3. Play the DVD Player.
Adjust the volume level using the VOLUME knob !2 on the front
4.
panel or press the VOL 5/ button . on the remote.
If necessary, adjust the tone, select the TRB+, TRB– and BAS+,
BAS– by the Jog Dial n and press ENT button m in the AMP
MODE on the remote unit.
Playing the DVD player/6ch-INPUT.
1. Set the INPUT SELECTOR knob to DVD on the front panel or
press the DVD of FUNCTION buttons twice on the remote unit.
2. Press the 6CH-INPUT on the front panel.
Select the 6-DIR by the Jog Dial n and press ENT button m in
the AMP MODE on the remote unit.
3. Play the DVD Player.
Adjust the volume level using the VOLUME knob !2 on the front
4.
panel or press the VOL 5/ button . on the remote.
Note.
The following functions do not work while 6CH-INPUT is selected:
input selection, surround mode selection, tone controls, attenuator.
To select the input, release the 6CH-INPUT first.
The same status prior to the selection of 6CH-INPUT is maintained for
the video output. If, for instance, 6CH-INPUT is selected after DVD
was selected, the audio system will change to 6CH-INPUT but DVD is
maintained for the video output.
15