Table of Contents
Advertisement
7.
Repeat the procedure from step 3 to have the remote controller
learn the signal codes for the other components such as TV, VCR,
etc.
• If no buttons are pressed for approximately 1 minute while in
the LEARN mode, the remote controller automatically returns
to the USE mode.
• When programming the function buttons, first switch to the
desired function, then press the button again.
8.
When you have finished programming the remote controller, use
a ballpoint pen or other sharp point to once again press the
MODE button z to return it to the USE mode. The LCD displays
the USE indicator, and the newly programmed codes now can be
used.
If FULL is displayed on the LCD
If FULL is displayed on the LCD b when programming in the LEARN
mode, it means that the memory has become too full to hold any
further codes.
If FULL is displayed no matter how many times you attempt to enter
new codes, it means that the remote controller cannot accept any
new codes until some of the previously learned codes are deleted to
make space in the memory. Select unneeded codes for each of the
Jog Dial control n and Functionbuttons , , which show FULL and
delete them from the memory.
Note:
The power ON and OFF buttons c can only be programmed to
learn one type of code, regardless of the function button that has
been selected.
PROGRAMMING THE JOG DIAL
Let's use the example of setting
disc player.
1.
Use a ballpoint pen or other sharp point to press the MODE
button z until the LEARN indicator is displayed and starts to
blink.
2.
Place the laser disc's remote controller so that its infrared
transmitter window is facing the infrared signal receiver window
on the Marantz remote controller at a distance of about 5
centimeters (2 inches).
Press the LD Function button ,.
3.
Rotate the Jog Dial n left or right until
4.
the ENT button m.
• The LEARN and NAME indicators will both be displayed.
5.
Press the SIDE-B button on the laser disc's remote controller
continuously until OK is displayed on the Marantz remote
controller's LCD, indicating that the programming has been
completed.
• If AGAIN appears on the LCD, some error has prevented the
command from being learned. If this happens, simply repeat
the procedure from step 4.
When the programming has been completed, the remote
controller automatically switches to the NAME mode.
The left hand position on the LCD
character in the name to be rewritten.
• If you do not wish to rewrite the name, simply press the
Cursor button ⁄0 .
• If you wish to rewrite the name, input the desired characters
using the ten-key pad ⁄7 . The part of the display that is being
rewritten may be selected using the
⁄0 . When you are finished rewriting, press the
button ⁄0 .
To simply erase already existing characters, press the 0
button to replace them with a blank space.
(Refer to next section on rewriting names)
6.
Use the same procedure to program the codes for other 1-6 with
the Jog Dial n.
7.
When finished programming the codes for each of the buttons,
use a ballpoint pen or other sharp point to press the MODE
button z to return the remote controller to the USE mode. Once
USE is displayed on the LCD, the newly memorized codes are
available for use.
25
as the SIDE-B code for the laser
is displayed, then press
b blinks, indicating the
OK
< and > Cursor buttons
OK Cursor
Advertisement
Table of Contents
