Table of Contents
Advertisement
Quick Links
FOREWORD
This section must be read before any connection is made to
the mains supply.
WARNINGS
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not push anything inside the equipment through the
ventilation holes.
Do not handle the mains lead with wet hands.
EQUIPMENT MAINS WORKING SETTING
Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your
area.
This product can be powered by 120 V AC only.
COPYRIGHT
Recording and playback of any material may require consent.
For further information refer to the following:
— Copyright Act 1956
— Dramatic and Musical Performers Act 1958
— Performers Protection Acts 1963 and 1972
— any subsequent statutory enactments and orders
ABOUT THIS USER GUIDE
Refer to the Figures on the page 10 at the rear of this user
guide. The numbers on the diagrams correspond to those in
the text. All references to the connections and controls that
are printed in BOLD type are as they appear on the unit.
PRECAUTIONS
The following precautions should be taken when operating the
equipment.
GENERAL PRECAUTIONS
When setting the equipment ensure that:
— the ventilation holes are not covered
— air is allowed to circulate freely around the equipment
— it is on a vibration free-surface
— it will not be exposed to interference from an external source
— it will not be exposed to excessive heat, cold, moisture or
dust
— it will not be exposed to direct sunlight
— it will not be exposed to electrostatic discharges
Never place heavy objects on the equipment.
If a foreign body or water does enter the equipment, contact
your nearest dealer or service centre.
Do not pull out the plug by pulling on the mains lead, hold the
plug.
It is advisable when leaving the house, or during a thunder-
storm, to disconnect the equipment from the mains supply.
SM-17SA
The SM-17SA is a power amp that can be switched between
stereo and monaural operation (BTL operation). In addition,
the SM-17SA is equipped with a line amp that is compatible
with fast BTL amps. This capability makes an even more ad-
vanced audio system possible by allowing you to connect an-
other power amp to your system so that you can implement bi-
amp drive for the speaker system.
1
Advertisement
Table of Contents
Related Manuals for Marantz SM6100SA
Summary of Contents for Marantz SM6100SA
- Page 1 This product can be powered by 120 V AC only. If a foreign body or water does enter the equipment, contact your nearest dealer or service centre. Do not pull out the plug by pulling on the mains lead, hold the plug. COPYRIGHT It is advisable when leaving the house, or during a thunder- Recording and playback of any material may require consent.
-
Page 2: Connection Of Speaker Systems
Caution: If you will be using two speaker systems, or you will be using the SM-17SA in BTL mode, use speaker systems that have an impedance of at least 8 ohm. If you connect a speaker system that has an impedance of less than 8 ohm, the SM-17SA’s protective circuitry may be worked, making the amplifier incapable of normal stereo playback. - Page 3 SPEAKERS IMPEDANCE L+R:4-8 OHMS BTL:8-16 OHMS SPEAKERS Example 2: Bi-amp connection with a PM-17SA + two SM-17SAs This example uses two SM-17s, each in BTL operation mode. This setup can powerfully drive the speaker systems bass driver unit. SPEAKERS SPEAKERS IMPEDANCE L+R:4-8 OHMS BTL:8-16 OHMS...
-
Page 4: Troubleshooting
The ATT switch is an attenuator switch that reduces the amp Press to turn power ON and press again to turn it OFF. gain by 6dB so that the gain is same with the gain that is out- Meter w lights up when the POWER is turned ON. - Page 5 TECHNICAL SPECIFICATIONS (DIN) Rated power output (20 Hz to 20 kHz 2 CH simultaneous drive) ..................60W x 2 (8 Ω load) 80W x 2 (6 Ω load) 100W x 2 (4 Ω load) (20 Hz to 20 kHz BTL drive) ......................200W x 1 (8 Ω load) Total harmonic distortion (20 Hz to 20 kHz 2 CH drive, 8 Ω...
- Page 6 AC IN 1.0A 120W MAX TOTAL 1.0A 120W MAX NORMAL SPEAKERS IMPEDANCE L&R : 4 OHMS BTL : 8 OHMS SWITCHED UNSWITCHED (dB) INPUT BTL OUT SPEAKERS 120V 60HZ AC OUTLETS SERIAL NO. INTEGRATED AMPLIFIER SM-17 TEMP POWER...
Need help?
Do you have a question about the SM6100SA and is the answer not in the manual?
Questions and answers