Table of Contents
Advertisement
FS-8700-41 Simplex 4100 Driver Manual
Array
Attribute
Value
Posn
0
Not Defined
10
1
PRIMARY STATUS
14 (Normal)
2
PHYSICAL STATE
3
RAW STATE
4
ACTIVE STATE
5
ARMED STATE
6
ENABLED STATE
11 (Enabled)
7
UNVERIFIED
0
4 (Correct
8
CURRENT DEVICE
Device)
9
DEVICE
12 (On_Line)
3 (Self test
10
TEST STATE
normal)
PRESENT SENSITIVITY
11
SELECTED
14
AVERAGE
17
VALUE
0
18
-41
19
20
PEAK
0
21
-41
22
6 (Range
23
TROUBLE THRESHOLD
Normal)
24
OUTPUT STATE
25
OUTPUT STATUS
26
DETECTOR SOUNDER
ALARM TEMPERATURE
27
135
SELECTED=
30
DETECTOR RELAY
4
Locations marked with a 1 are updated when the driver analyses this response
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Filled
Note
In4
The value 10 represents the count of the number of attributes that were extracted from the response. It is not equal to the number of array
1
locations filled in because some attributes (e.g. Value) result in more than one array location being updated.
1
#
The un-filled-in locations are not updated by the driver when this response is analysed because the attributes corresponding to these
locations were not reported in the response to the query.
1
1
1
1
1
1
1
Room for up two three numbers for attributes like value, peak but in this case only two values are relevant for this device
1
1
Room for up two three numbers for attributes like value, peak but in this case only two values are relevant for this device
1
1
Page 26 of 48
Advertisement
Table of Contents
