Page 1
Driver Manual (Supplement to the FieldServer Instruction Manual) FS-8700-43 Vesda APPLICABILITY & EFFECTIVITY Effective for all systems manufactured after January 2012 A Sierra Monitor Company Driver Version: 1.03 Document Revision:...
FS-8700-43 VESDA Driver Manual VESDA DESCRIPTION The VESDA driver allows the FieldServer to transfer data to and from devices over RS-232 using VESDA protocol. The FieldServer can emulate a VESDA Client. The information that follows describes how to expand upon the factory defaults provided in the configuration files included with the FieldServer.
This section documents and describes the parameters necessary for configuring the FieldServer to communicate with a Vesda Server. The configuration file tells the FieldServer about its interfaces, and the routing of data required. In order to enable the FieldServer for Vesda communications, the driver independent FieldServer buffers need to be declared in the “Data Arrays”...
Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction manual for details of the ports available on specific hardware. FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com , Timeout , 10.0s...
ONLY 1 OF THE 8 BITS MAY BE SET IN ONE COMMAND FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com Legal Values...
The zone number Sector* The sector number FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com Legal Values Up to 15 alphanumeric characters Float...
Appendix B.1. VESDA Panel start-up delay. When the HLI is powered on the FieldServer will not be able to communicate with the Panel for 10 to 30 seconds. During this time the HLI starts up its application code and initializes various internal parameters.