FS-8700-40 SBT FSI Driver Manual
3
HARDWARE CONNECTIONS
3.1
Using the NIM-1R or NIM-1W for MXL
Configure the NIM-1R
to open (or OFF). See connection diagram below:
Connect the NIM-1R to an RS-232 port on the Fieldserver as depicted in the fiagram below (brown circle)
Connect the NIM-W to an RS-485 port on the FieldServer as depeicted in the diagram below.
TB4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
3
Note that NIM-1R is no longer supported by Siemens and is therefore considered to be legacy while NIM-1W is common.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
3
or NIM-1W for Foreign System Interface (FSI) by setting all of the switches in SW2
RS-485
Opto
Isolated
FieldServer
Cerberus Cable
P/N 555-193085
FS-8917-03
RJ45 to
DB9M
FS-8917-03
Connector
RJ45 CAT 5 Cable
FS8915-10
NIM-1R
Connection
8
1
P1
Page 4 of 34