Table of Contents
Advertisement
FS-8704-14 EtherNet/IP Manual
Page 5 of 30
3
HARDWARE CONNECTIONS
1
It is possible to connect an EtherNet/IP device to either port N1 or N2
on the FieldServer. These ports must just
be configured to use EtherNet/IP in the configuration file.
Remote Ethernet/IP
Device
Hub/Router
FieldServer Part #
8915-10
UTP cable
Connect to an Ethernet Port
on the FieldServer
8
1
FieldServer
N1
1
Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction manual for details of the ports available
on specific hardware.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Advertisement
Table of Contents
