[B] Sanitizing Procedure - Hoshizaki KM-61BAH Service Manual

15) Same as step 1.
16) Wash the Bin Control Switch, Water Tank, Float Switch, Cube Guide, Silicone Hose
and Overfl ow Pipe by using a nylon scouring pad, brushes and the cleaning solution.
In addition to the removed parts, also wash the bin liner and Bracket (L) (R) with the
solution.
17) Discard the cleaning solution and rinse the parts thoroughly with water.
[b] SANITIZING PROCEDURE - Following Cleaning Procedure
1) Dilute approximately 0.5 fl. oz. (15 ml or 1 tbs) of a 5.25% sodium hypochlorite
solution (chlorine bleach) with 1 gallon (3.8 lit.) of warm water. Using a chlorine test
strip or other method, confi rm that you have a concentration of about 200 ppm.
2) Soak the removed parts from step 16 above in a clean container containing the
sanitizing solution. After allowing the parts to soak for 10 minutes, wash them with
the solution. Also wash the bin liner, Bracket (L) (R) with the solution.
3) Discard the sanitizing solution and rinse the parts thoroughly with water.
4) Replace the removed parts in their correct positions in the reverse order of which
they were removed.
5) Same as step 1.
6) Pour the sanitizing solution into the Water Tank, and allow the sanitizer to sit for 10
minutes.
7) Move the Control Switch to the "WASH" position. Close the Door.
8) After 15 minutes, move the Control Switch to the "OFF" position. Open the Door.
9) Disconnect the Silicone Hose to drain the water. Reconnect the Silicone Hose back
in its correct position after all of the water has drained.
10) Repeat steps 5 through 9 one time. Repeat steps 8 through 11 in the Cleaning
Procedure three times to rinse thoroughly.
11) Flush the Storage Bin with water.
12) Move the Control Switch to the "ICE" position, and start the automatic icemaking
process.
13) Close the Door. Replace the Air Filter in its correct position.
74