Water Regulating Valve - Km-151Bwh Only - Hoshizaki KM-61BAH Service Manual

7. WATER REGULATING VALVE - KM-151BWH ONLY

Always install a new Drier every time the sealed refrigeration system is
opened. Do not replace the Drier until after all other repair or replacement
has been made.
1) Unplug the icemaker or disconnect the power source.
2) Close the water supply line Shout-off Valve.
3) Remove the Louver, Top Panel, Rear Panel, Rear Cover and Pipe Cover.
4) Recover the refrigerant and store it in a container, if required by applicable law (see "1.
[b] REFRIGERANT RECOVERY").
5) Remove the Inlet Nut for the Water Valve.
6) Remove the four bolts securing the body at the front and rear.
7) Lift up the front of the body, and place a block between the body and base to allow
space for servicing.
Support body with hard
object (block) and use
this space for servicing.
8) Disconnect the Capillary Tube at the Condenser outlet.
9) Disconnect the fl are connections of the Water Valve.
10) Unscrew the Bracket, and remove the Water Valve from the Bracket.
11) Install the new Water Valve.
IMPORTANT
Lift up
Fig. 7
50
Body
Base