Bin Control Switch - Hoshizaki KM-61BAH Service Manual

7) Put the Float Switch down into the mounting hole and hook it in position as shown.
To ensure proper operation, be sure to fi t the Hook (A) under the mounting hole.
8) Refi t the removed parts in the reverse order of the removal procedure.
9) Plug in the icemaker or connect the power source.

16. BIN CONTROL SWITCH

1) Unplug the icemaker or disconnect the power source.
2) Remove the Top Panel and unscrew the Rear Panel.
3) Disconnect the Connector of the Bin Control Switch lead (black) covered with a
silicone hose and remove the lead wire from the Grommet.
4) Remove the Water Tank (see "19. WATER TANK"). The Bin Control Switch is located
as shown below when viewed from the front.
5) Pull down and remove the lead wire from the retainer on the right side of the Bin
Control Switch.
6) Hold both sides of the Bin Control Switch and pull it toward you.
Fig. 18
Separator
Fig. 19
61
Bin Control Switch
Mounting Hole