Lifting & Placing Mill - Grizzly G0726 Owner's Manual

Lifting & Placing Mill
The Model G0726 is a
heavy machine. Serious
personal injury may occur
if safe moving methods are
not used. To be safe, get
assistance and use power
equipment rated for at least
4500 lbs. to move the ship-
ping crate and remove the
machine from the crate.
Lifting and placing the mill requires at least two
other people for assistance and a forklift with two
lifting straps, lifting chain, and a safety hook rated
for at least 4500 lbs. each.
To lift and move the mill:
1.
Position ram and headstock as illustrated in
Figure 5 (refer to Head Movement on Page
32 and Ram Movement on Page 33 for
detailed instructions).
Note: After re-positioning ram and head-
stock, make sure they are locked in place to
prevent unexpected movement during lifting
and moving.
Figure 5. Correct ram and head position before
lifting.
-18-
2. Place lifting straps under ram and connect
them to forklift safety hook and chain, as illus-
trated in Figure 6.
Note: Place padding between straps and mill
to protect ram and ways, and to keep from
cutting lifting straps.
Lifting
Straps
Figure 6. Lifting straps attached to safety hook
and chain in preparation for lifting.
3. Unbolt mill from shipping pallet.
4. With your assistants steadying the mill to
keep it from swaying, lift mill a couple of
inches.
— If mill tips to one side, lower it to the ground
and adjust ram or table to balance load.
Make sure to re-tighten lock levers and
bolts before lifting mill again.
— If mill lifts evenly, continue to move it to its
permanent location.
Model G0726 (Mfg. Since 7/11)
Safety Hook
& Chain